|
Post by Addicted on Sept 24, 2013 7:02:38 GMT -6
So I have an issue with bolting my new to me seats into my '71 Wagoneer. I am either missing something or I gots parts that don't fit. This is a pic of the drivers side brackets in the rear. The seat slider holes are about 12.5" apart. This is the front of those same brackets the seat slider holes are about 11" apart This is the seat bottom and the holes are about 13.5" apart. I don't see how they are going to bolt to the sliders.
|
|
|
Post by Ristow on Sept 24, 2013 7:10:24 GMT -6
make certain the 4 seat brackets are oriented correctly.
|
|
|
Post by Addicted on Sept 24, 2013 8:03:11 GMT -6
I've got them orientated as best as I can figure they should be. From what i figure, the shortest one is for the passenger inner seat that sits on the t-case hump. The other shorter one is the pass outer and the two taller ones are for the drivers seat. I can't imagine that the floor console equipped jeeps have different seats and brackets than the models with the arm rest center seat.
|
|
|
Post by Ristow on Sept 24, 2013 8:17:56 GMT -6
yeah,i doubt the brackets changed. the floor holes sure would be the same.
|
|
|
Post by Addicted on Sept 24, 2013 8:25:17 GMT -6
this is the only pre '80 i've paid much attention to. Do all of them have that drivers inner rear floor bolt offset towards the hump.
|
|
|
Post by Ristow on Sept 24, 2013 8:27:37 GMT -6
i think so. i haven't really paid a lot of attention to the floor bolts either.
|
|
|
Post by WH on Sept 24, 2013 15:55:20 GMT -6
These are of the Passenger seat for an 80 FSJ. The seat bolts that the sliders attach to are 13 5/8" or so. The taller bracket is to the outside, by the door, the shorter one gets into the hump. The 79 or older would have a different hump, I do not know if this will help, but it is the best I can do for you.
|
|
|
Post by Addicted on Sept 24, 2013 17:33:02 GMT -6
Unfortunately the risers and floor are different for the per '80 models.
|
|
|
Post by Ristow on Sept 30, 2013 7:03:41 GMT -6
are they in yet? you got the brackets now......
|
|
|
Post by Addicted on Sept 30, 2013 7:16:40 GMT -6
They were in on Wednesday with the original brackets from my Jeep. I'll be pulling them out after I clean up the set I got from you and giving them back to HonchV8.
|
|